English
简体中文The hydraulic control system of the motorcycle lift is the key to the operation of the entire lift platform, so it should be paid attention to during production and use. The following will introduce you to the steps of the hydraulic control system in the operation of the motorcycle lift.
1. Hydraulic control system of ordinary motorcycle lift
When in use, make sure to turn the oil return valve knob back clockwise, pull the manual reversing valve handle to the "neutral" position, start the motor to make the system work, then pull the reversing handle to the "raise" position. " position. When the hydraulic lift platform is raised and reaches the desired height, the motorcycle lift platform stops moving. When the reversing handle is pushed to the "neutral" position, the motor will turn off.
When descending, the oil return valve is released, and the motorcycle lifting platform can be lowered by its own weight. A spare hand pump has been added to the hydraulic control system of the motorcycle lift and can be used without power. When using a hand pump, first tighten the oil return valve knob clockwise, pull the handle to the "neutral" position, then press the handle to lift it. Loosen the return valve knob when descending. The lift table of the motorcycle is lowered due to its own weight. The method of operation when using an electric motor or diesel engine at that time.
2. Electromagnetic reversing valve hydraulic control system
First press the motor switch. When the pump is pumping, the pump is unloaded. Press the start switch, the electromagnetic reversing valve 1dt works, and the motorcycle lifting platform is lifted. Once the desired working height is reached, the lift switch can be turned off for operation. After pressing the switch, the electromagnetic reversing valve 2DT works, and the motorcycle lifting platform drops to the original position due to its own weight.
3. The hydraulic system is controlled by the auxiliary valve
First, start the motor switch, the motor rotates, the gear pump pumps oil, the cylinder extends, and the motorcycle lifts up; when it rises to the desired height, press the motor stop button, and the motorcycle lift platform will stop lifting, Then run. By pressing the electromagnetic button, the motorcycle lift platform is now connected to the cylinder, and the hydraulic lift platform has its own weight.
