The hydraulic control system of the motorcycle lifting platform is the key to the operation of the entire lifting platform, so attention must be paid during production and use. The following will introduce you to the steps of the hydraulic control system during the operation of the motorcycle lift table.
1、 Hydraulic Control System for Lifting Platform of Ordinary Motorcycle
When using, be sure to tighten the oil return valve knob clockwise, pull the manual reversing valve handle to the "neutral" position, start the motor to make the system work, and then pull the reversing handle to the "raised" position. When the hydraulic lifting platform is lifted and reaches the required height, the motorcycle lifting platform stops moving. When the reversing handle is pushed to the "neutral" position, the motor shuts down.
When lowering, the return valve is released, and the motorcycle lift table can be lowered by its own weight. Add a standby manual pump to the hydraulic control system of the motorcycle lift table, which can be used without power supply. When using a manual pump, first tighten the knob of the oil return valve clockwise, pull the handle to the "neutral" position, and then press the handle to lift. Loosen the return valve knob when lowering. The motorcycle lift table descends due to its own weight. The method of operation when using electric motors or diesel engines.

2、 Hydraulic control system of electromagnetic directional valve
First press the motor switch. When the oil pump is pumping, the oil pump is in the unloading state. Press the start switch, the electromagnetic reversing valve 1DT operates, and the motorcycle lifting platform lifts. After reaching the required working height, the lift switch can be turned off for operation. Press the switch, the electromagnetic directional valve 2DT operates, and the motorcycle lift table descends to the original position through its own weight.

3、 Support valve control hydraulic system
First, start the motor switch, the motor rotates, the gear pump draws oil, the cylinder extends, and the motorcycle lift table rises; When raising to the required height for work, press the motor stop button, and the motorcycle lift table will stop lifting, then proceed with the operation. Press the electromagnet button, and the motorcycle lifting platform is now connected to the oil cylinder. The hydraulic lifting platform has its own weight.
The above is the operation steps of the hydraulic control system for the motorcycle lifting platform, and I hope to be helpful to everyone.